1/16 Rc GTK Boxer 8x8 styreen project

[karel47]

so that's the boxer up to now , a lot done but must be do a lot more to complete the detailing

the boxer is a modular vehicle as you all know






basicly the chassis must be like this , the pics are from gerhards boxerbuild

[Leo1A4]

Karel bastelt wieder: Sehr schön
Jetzt hast du dir die Radpanzer vorgenommen - und gleich einen dicken Brocken.
Sieht sehr gut aus bis hierhin. Wird ein schönes Modell

[karel47]

another update the backhatch moving system
no 3d printing just cutted out with hobbyknife ... and gleud it with MEK














MEK

[karel47]

another update today made the scalethickness off the backhatch correct and just need up to armor the door a bit so its legal with the hatch itself











the airvent on the boxers right side were nice but i decided to cut them open with modellersknive , it seems that part need a bit bowing inside too , i go look into that










the chassis needed a little correction too ... so we cutted it loose and regleu it with MEK

[karel47]

another detail came up ... ludwig part is ready for it , its allready cutted in were the bend is comming , just warming up above the stove and bending a bit







mission completed airvents cutted out and bended on place , gleud with MEK









first let it dry up and let the mek harden out and tomorrow cleaning the parts
maybe add rubber like on the real ones to prevent dust to cume in

[karel47]

a few new things done

[karel47]

the michelins in scale my boxer's tyres

[karel47]

a few new thinks in the make















not finished yet
yes need to finish a lot of seems with putty but in the end it would be worth , have no 3d printer , cannot design stuff for it , so its all hand cutted stuff except a few ludwigs seite stuff

[karel47]

i placed the nebelwerpfers just before nightshift in a hurry , did not look at the pic in my book , saw afterwards they had to be mounted sideways , i must say MEK gleu very well , i could lift the boxer by lifting it up on the smokers so it was cutting but now its corrected , again cleaned and gleud by mek , enjoy it ...

na wat studie en een opmerking van een collega rc tanker , viel mijne euro ... had in mn enthousiasme net voor mn nachtshiftde smokers recht erop gekeefd in plaats van van deze schuin te plaatsen zoals de foto in mn boek , niet naar gekeken natuurlijk en vlug vlug erop gekleefd net voor het werk

hier volgd de correctie

[karel47]

Update 14 : fronthinges pantserplate











before as ludigs seite made it without the hinges ... not so difficult to made , only timeconsuming , testing , trying for measurments and then finaly cutting out and finetuning